|
Sipex |
® SP3222E/3232E
True +3.0V to +5.5V RS-232 Transceivers
■ Meets true EIA/TIA-232-F Standards
from a +3.0V to +5.5V power supply
■ Minimum 120Kbps Data Rate Under Full
Load
■ 1µA Low-Power Shutdown with Receivers
Active (SP3222E)
■ Interoperable with RS-232 down to +2.7V
power source
■ Enhanced ESD Specifications:
±15kV Human Body Model
±15kV IEC1000-4-2 Air Discharge
±8kV IEC1000-4-2 Contact Discharge
DESCRIPTION
The SP3222E/3232E series is an RS-232 transceiver solution intended for portable or hand-
held applications such as notebook or palmtop computers. The SP3222E/3232E series has
a high-efficiency, charge-pump power supply that requires only 0.1µF capacitors in 3.3V
operation. This charge pump allows the SP3222E/3232E series to deliver true RS-232
performance from a single power supply ranging from +3.3V to +5.0V. The SP3222E/3232E
are 2-driver/2-receiver devices. This series is ideal for portable or hand-held applications such
as notebook or palmtop computers. The ESD tolerance of the SP3222E/3232E devices are
over ±15kV for both Human Body Model and IEC1000-4-2 Air discharge test methods. The
SP3222E device has a low-power shutdown mode where the devices' driver outputs and
charge pumps are disabled. During shutdown, the supply current falls to less than 1µA.
SELECTION TABLE
MODEL Power Supplies
SP3222
SP3232
+3.0V to +5.5V
+3.0V to +5.5V
RS-232
Drivers
2
2
RS-232
External
Receivers Components
24
24
Shutdown
Yes
No
TTL No. of
3-State Pins
Yes 18, 20
No 16
Rev. 11/07/02
SP3222E/3232E True +3.0 to +5.0V RS-232 Transceivers
1
© Copyright 2001 Sipex Corporation
ABSOLUTE MAXIMUM RATINGS
These are stress ratings only and functional operation of the
device at these ratings or any other above those indicated in
the operation sections of the specifications below is not
implied. Exposure to absolute maximum rating conditions
for extended periods of time may affect reliability and cause
permanent damage to the device.
VCC................................................................-0.3V to +6.0V
V+ (NOTE 1)................................................-0.3V to +7.0V
V- (NOTE 1)................................................+0.3V to -7.0V
V+ + |V-| (NOTE 1)....................................................+13V
ICC (DC VCC or GND current).................................±100mA
Input Voltages
TxIN, EN ................................................... -0.3V to +6.0V
RxIN .......................................................................... ±15V
Output Voltages
TxOUT ...................................................................... ±15V
RxOUT ........................................... -0.3V to (VCC + 0.3V)
Short-Circuit Duration
TxOUT ............................................................ Continuous
Storage Temperature .............................. -65°C to +150°C
Power Dissipation Per Package
20-pin SSOP (derate 9.25mW/oC above +70oC) ..... 750mW
18-pin PDIP (derate 15.2mW/oC above +70oC) .... 1220mW
18-pin SOIC (derate 15.7mW/oC above +70oC) ... 1260mW
20-pin TSSOP (derate 11.1mW/oC above +70oC) .. 890mW
16-pin SSOP (derate 9.69mW/oC above +70oC) ..... 775mW
16-pin PDIP (derate 14.3mW/oC above +70oC) .... 1150mW
16-pin Wide SOIC (derate 11.2mW/oC above +70oC) 900mW
16-pin TSSOP (derate 10.5mW/oC above +70oC) .. 850mW
16-pin nSOIC (derate 13.57mW/°C above +70°C) .. 1086mW
NOTE 1: V+ and V- can have maximum magnitudes of 7V, but their absolute difference cannot exceed 13V.
SPECIFICATIONS
Unless otherwise noted, the following specifications apply for VCC = +3.0V to +5.0V with TAMB = TMIN to TMAX
PARAMETER
MIN. TYP. MAX. UNITS CONDITIONS
DC CHARACTERISTICS
Supply Current
0.3
Shutdown Supply Current
1.0
LOGIC INPUTS AND RECEIVER OUTPUTS
1.0 mA no load, TAMB = +25oC, VCC = 3.3V
10 µA SHDN = GND, TAMB = +25oC, VCC = +3.3V
Input Logic Threshold LOW
Input Logic Threshold HIGH
2.0
2.4
Input Leakage Current
±0.01
Output Leakage Current
±0.05
Output Voltage LOW
Output Voltage HIGH
DRIVER OUTPUTS
VCC-0.6 VCC-0.1
Output Voltage Swing
±5.0 ±5.4
0.8
±1.0
±10
0.4
V TxIN, EN, SHDN, Note 2
V VCC = 3.3V, Note 2
V = 5.0V, Note 2
CC
µA TxIN, EN, SHDN, TAMB = +25oC
µA receivers disabled
V IOUT = 1.6mA
V IOUT = -1.0mA
V 3kΩ load to ground at all driver outputs,
TAMB = +25oC
Output Resistance
Output Short-Circuit Current
300
Output Leakage Current
Ω VCC = V+ = V- = 0V, TOUT = +2V
±35 ±60 mA VOUT = 0V
±70 ±100 mA VOUT = +15V
±25 µA VOUT = +12V,VCC= 0V to 5.5V,drivers disabled
Rev. 11/07/02
SP3222E/3232E True +3.0 to +5.0V RS-232 Transceivers
2
© Copyright 2002 Sipex Corporation
|