|
ETC |
AP1084
5A Low Dropout Positive Adjustable or Fixed-Mode Regulator
Features
General Description
• 1.4V maximum dropout at full load current
• Built-in thermal shutdown
• Output current limiting
• Adjustable output voltage or fixed 1.5V, 1.8V, 2.5V,
3.3V, 5.0V
• Fast transient response
• Good noise rejection
• Package : TO252, TO263, TO220
AP1084 is a low dropout positive adjustable or fixed-
mode regulator with minimum of 5.0A output current
capability. The product is specifically designed to
provide well-regulated supply for low voltage IC
applications such as high-speed bus termination and
low current 3.3V logic supply. AP1084 is also well
suited for other applications such as VGA cards.
AP1084 is guaranteed to have lower than 1.4V
dropout at full load current making it ideal to provide
well-regulated outputs of 1.25 to 3.3V with 4.7 to
12V input supply.
Ordering Information
AP1084 X X X X
Low Dropout Regulator
Package
D : TO252-3L
K : TO263-3L
T : TO220-3L
Vout
Blank : Adj
15 = 1.5V
18 = 1.8V
25 = 2.5V
33 = 3.3V
50 = 5.0V
Lead Free
Packing
Blank : Normal
Blank : Tube
L : Lead Free Package A : Taping
Typical Circuit
5.0V to 3.3V Fixed Mode Regulator
5V
C1
100uF
Vin
Vout
GND
Tab is Vout
3.3V/5A
C2
100uF
Adjustable Regulator
5V C1
100uF
Vin
Vout
2.5V/5A
Adj
Tab is Vout
R1 121Ω
R2 121Ω
C2
100uF
Note:
Vo
=
VREF
∗
(1+
R2
R1
)
This datasheet contains new product information. Anachip Corp. reserves the rights to modify the product specification without notice. No liability is assumed as a result of the use of
this product. No rights under any patent accompany the sale of the product.
Rev.1.0 Aug.27, 2004
1/10
AP1084
5A Low Dropout Positive Adjustable or Fixed-Mode Regulator
Block Diagram
Vin 3
Thermal
Shutdown
Connection Diagram
TO263
FRONT VIEW
3 Vin
2 Vout
1 Adj (GND)
Tab is Vout
Pin Descriptions
2 Vout
+
+-
CURRENT
LIMIT
1.25V +
+
1 Adj
TO252
FRONT VIEW
3 Vin
2 Vout
1
Tab is Vout
Adj (GND)
TO220
FRONT VIEW
3
2
1
Vin
Vout
Adj (GND)
Tab is Vout
NAME
I/O PIN #
FUNCTION
Adj (GND)
1 Adjustable (Ground only for fixed mode)
Vout
Vin
O
2
The output of the regulator. A minimum of 10uF capacitor must be
connected from this pin to ground to insure stability.
The input pin of regulator. Typically a large storage capacitor is connected
from this pin to ground to insure that the input voltage does not sag below
I 3 the minimum dropout voltage during the load transient response. This pin
must always be 1.4V higher than Vout in order for the device to regulate
properly.
Anachip Corp.
www.anachip.com.tw
Rev.1.0 Aug.27, 2004
2/8
|