DataSheet.es    


PDF 74ACTQ16245 Data sheet ( Hoja de datos )

Número de pieza 74ACTQ16245
Descripción 16-Bit Transceiver with 3-STATE Outputs
Fabricantes Fairchild Semiconductor 
Logotipo Fairchild Semiconductor Logotipo



Hay una vista previa y un enlace de descarga de 74ACTQ16245 (archivo pdf) en la parte inferior de esta página.


Total 7 Páginas

No Preview Available ! 74ACTQ16245 Hoja de datos, Descripción, Manual

May 1991
Revised November 1999
74ACTQ16245
16-Bit Transceiver with 3-STATE Outputs
General Description
The ACTQ16245 contains sixteen non-inverting bidirec-
tional buffers with 3-STATE outputs and is intended for bus
oriented applications. The device is byte controlled. Each
has separate control inputs which can be shorted together
for full 16-bit operation. The T/R inputs determine the direc-
tion of data flow through the device. The OE inputs disable
both the A and B ports by placing them in a high imped-
ance state.
The ACTQ16245 utilizes Fairchild Quiet Seriestechnol-
ogy to guarantee quiet output switching and improved
dynamic threshold performance. FACT Quiet Seriesfea-
tures GTOoutput control for superior performance.
Features
s Utilizes Fairchild FACT Quiet Series technology
s Guaranteed simultaneous switching noise level and
dynamic threshold performance
s Guaranteed pin-to-pin output skew
s Bidirectional non-inverting buffers
s Separate control logic for each byte
s 16-bit version of the ACTQ245
s Outputs source/sink 24 mA
s Additional specs for multiple output switching
s Output loading specs for both 50 pF and 250 pF loads
Ordering Code:
Order Number Package Number
Package Description
74ACTQ16245SSC
MS48A
48-Lead Small Shrink Outline Package (SSOP), JEDEC MO-118, 0.300Wide
74ACTQ16245MTD
MTD48
48-Lead Thin Shrink Small Outline Package (TSSOP), JEDEC MO-153, 6.1mm Wide
Device also available in Tape and Reel. Specify by appending suffix letter “X” to the ordering code.
Logic Symbol
Connection Diagram
Pin Description
Pin Names
OEn
T/R
A0A15
B0B15
Description
Output Enable Input (Active LOW)
Transmit/Receive Input
Side A Inputs/Outputs
Side B Outputs/Inputs
FACT, FACT Quiet Seriesand GTOare trademarks of Fairchild Semiconductor Corporation.
© 1999 Fairchild Semiconductor Corporation DS010926
www.fairchildsemi.com

1 page




74ACTQ16245 pdf
FACT Noise Characteristics
The setup of a noise characteristics measurement is critical
to the accuracy and repeatability of the tests. The following
is a brief description of the setup used to measure the
noise characteristics of FACT.
Equipment:
Hewlett Packard Model 8180A Word Generator
PC-163A Test Fixture
Tektronics Model 7854 Oscilloscope
Procedure:
1. Verify Test Fixture Loading: Standard Load 50 pF,
500.
2. Deskew the HFS generator so that no two channels
have greater than 150 ps skew between them. This
requires that the oscilloscope be deskewed first. It is
important to deskew the HFS generator channels
before testing. This will ensure that the outputs switch
simultaneously.
3. Terminate all inputs and outputs to ensure proper load-
ing of the outputs and that the input levels are at the
correct voltage.
4. Set the HFS generator to toggle all but one output at a
frequency of 1 MHz. Greater frequencies will increase
DUT heating and effect the results of the measure-
ment.
VOHV and VOLP are measured with respect to ground reference.
Input pulses have the following characteristics: f = 1 MHz, tr = 3 ns,
tf = 3 ns, skew < 150 ps.
FIGURE 1. Quiet Output Noise Voltage Waveforms
5. Set the HFS generator input levels at 0V LOW and 3V
HIGH for ACT devices and 0V LOW and 5V HIGH for
AC devices. Verify levels with an oscilloscope.
VOLP/VOLV and VOHP/VOHV:
Determine the quiet output pin that demonstrates the
greatest noise levels. The worst case pin will usually be
the furthest from the ground pin. Monitor the output volt-
ages using a 50coaxial cable plugged into a standard
SMB type connector on the test fixture. Do not use an
active FET probe.
Measure VOLP and VOLV on the quiet output during the
worst case transition for active and enable. Measure
VOHP and VOHV on the quiet output during the worst
case active and enable transition.
Verify that the GND reference recorded on the oscillo-
scope has not drifted to ensure the accuracy and repeat-
ability of the measurements.
VILD and VIHD:
Monitor one of the switching outputs using a 50coaxial
cable plugged into a standard SMB type connector on
the test fixture. Do not use an active FET probe.
First increase the input LOW voltage level, VIL, until the
output begins to oscillate or steps out a min of 2 ns.
Oscillation is defined as noise on the output LOW level
that exceeds VIL limits, or on output HIGH levels that
exceed VIH limits. The input LOW voltage level at which
oscillation occurs is defined as VILD.
Next decrease the input HIGH voltage level, VIH, until
the output begins to oscillate or steps out a min of 2 ns.
Oscillation is defined as noise on the output LOW level
that exceeds VIL limits, or on output HIGH levels that
exceed VIH limits. The input HIGH voltage level at which
oscillation occurs is defined as VIHD.
Verify that the GND reference recorded on the oscillo-
scope has not drifted to ensure the accuracy and repeat-
ability of the measurements.
FIGURE 2. Simultaneous Switching Test Circuit
5 www.fairchildsemi.com

5 Page










PáginasTotal 7 Páginas
PDF Descargar[ Datasheet 74ACTQ16245.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
74ACTQ1624016-Bit Inverting Buffer/Line Driver with 3-STATE OutputsFairchild Semiconductor
Fairchild Semiconductor
74ACTQ16240MTD16-Bit Inverting Buffer/Line Driver with 3-STATE OutputsFairchild Semiconductor
Fairchild Semiconductor
74ACTQ16240SSC16-Bit Inverting Buffer/Line Driver with 3-STATE OutputsFairchild Semiconductor
Fairchild Semiconductor
74ACTQ1624416-Bit Buffer/Line Driver with 3-STATE OutputsFairchild Semiconductor
Fairchild Semiconductor

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar