|
Panavision Imaging |
ONE TE C H N O L O G Y PLACE – HOMER, NEW YORK 13077
TEL: +1 607 749 2000 FAX: +1 607 749 3295 www.PanavisionImaging.com / [email protected]
LIS-1024
High Performance Linear CMOS Image Sensor
The LIS-1024 image sensor is a high performance, very low noise linear image sensor designed for a wide variety
of applications including:
P/N: LIS-1024D-LG
16-pin LCC package
• Spectroscopy
• Bar Code Reading
• Edge Detection
• Contact Scanning
• Optical Character Recognition
• Encoding
• Position Detection
• And more.......
Description
The LIS-1024 Image Sensor consist of an array of ultra low dark current photo-diode pixels with performance
exceeding most Charge-Coupled Devices (CCD's). The device has multiple read out modes, including: Non-
Destructive, Dynamic Pixel Reset™ (DPR), and Frame Reset.
The Non-destructive mode enables extremely low noise measurements (approaching a single electron) through the
use of signal averaging, enabling the system to achieve near single electron noise performance, making the device
ideally suited for any high performance measurement application. In DPR mode, each pixel is reset as it is read,
ensuring each pixel integrates for the same amount of time. Other reset modes are also provided to give
exceptional control over exposure time and pixel read out. The Sensor also operates over an extended power
supply range of 2.8-5.0 VDC.
Operation is simplified by on-chip logic. The only external signals required are a clock with a frequency equal to
the desired pixel read rate, a reset mode selection, and an external reset to initiate read-out when running
asynchronously.
The LIS-1024 is supplied in a 16-pin LCC package as shown above.
PDS0001 REV R 04/14/09
© Panavision Imaging LLC 2004 -2009 All rights reserved.
Subject to change without notice.
Page 1 of 13
Key Features
• Low Cost
• Single Supply Operation
• Multiple read out modes
• Ultra Low Noise (≅ 1 e- via signal averaging)
• High Signal to Noise
• Non-Destructive read capable
• 1.0 kHz to 20.0 MHz Operation
• Very Low Dark Current
• Completely integrated Timing and Control
• Replaces CCD systems, not just the sensor
• 1 x 1024 pixel resolution
• 7.8 micron pitch x 125 microns tall
• Photo-active area: 7.988 mm x 125 microns
Functional Block Diagram
R
1026 1028 1029
SR
S/RFF Q
Pixel 1
Pixel 2
Pixel 3
Pixel XXX
Absolute maximum ratings, T A = 25°C unless otherwise noted, see Note 1, below. †
PDS0001 REV R 04/14/09
© Panavision Imaging LLC 2004 -2009 All rights reserved.
Subject to change without notice.
Page 2 of 13
|