|
Micropac Industries |
53024
SPST SOLID-STATE RELAY
Mii
HYBRID MICROELECTRONICS
PRODUCTS DIVISION
Features:
• Replacement for 690-2
• SPST, Normally Open
• 1000 V RMS Optical Isolation
• CMOS or TTL Compatible Input
• Power FET Output – Low On-state Resistance
• Full Military Temperature Operation:
-55ºC to +105ºC
• Military Environmental Screening Available
• Built and Tested to MIL-PRF-28750 utilizing the
test methods of MIL-STD-883C
• Qualified to 86001-001
Applications:
• Low level power control
• Current loop switches
• Isolated line driver
• Servo and synchro resolver control
• Military/Space general purpose switching
DESCRIPTION
The 53024 is a military SPST solid-state relay. This small, light-weight device is resistant to damage from shock and
vibration, and immune to contact-related problems (contamination, arcing) associated with mechanical equivalents.
Optical coupling between the input and output stages provides effective isolation up to 1000 volts AC RMS. Power FET
outputs eliminate bipolar offset, and minimize output voltage drop.
The control logic is TTL and CMOS compatible, and will accommodate bias supplies between 3.8 and 32 VDC. A built-in
Schmitt trigger increases noise margin when using the device in the CMOS input mode.
This solid-state relay is ideal for use in military systems, or wherever high reliability, low power actuation, and light weight are
design considerations. Applications include general purpose signal switching and electronic load control.
ABSOLUTE MAXIMUM RATINGS
Isolation Voltage ................................................................................................................................................. 1000 VAC RMS
Operating Temperature ............................................................................................................................ -55ºC to +105ºC Case
Storage Temperature .........................................................................................................................................-55ºC to +125ºC
Micropac Industries cannot assume any responsibility for any circuits shown or represent that they are free from patent infringement.
Micropac reserves the right to make changes at any time in order to improve design and to supply the best product possible.
MICROPAC INDUSTRIES, INC. HYBRID MICROELECTRONICS PRODUCTS DIVISION • 905 E. Walnut St., Garland, TX 75040 • (972) 272-3571 • Fax (972) 494-2281
53024
SPST SOLID-STATE RELAY
ELECTRICAL CHARACTERISTICS
TA = +25ºC
PARAMETER
Input (Control) Characteristics
TTL Configuration
Input Current
Control Voltage Range
Turn-Off Voltage Maximum
Turn-On Voltage Minimum
Input (Control) Characteristics
CMOS Configuration
Input Current
Control Voltage Range
Bias Supply - VC
Bias Current
Turn-Off Voltage Minimum
Turn-On Voltage Maximum
Total Schmitt Hysteresis
CONDITIONS
See Table 1 – Bias Resistance
VC = + 5 VDC
See Table 1 – Bias Resistance
MIN
3.8
3.8
2.5
3.8
0.5
TYP
13
25
13
2.5
1.8
MAX
16
32
1.5
250
18
32
16
2.8
UNITS
mA
VDC
VDC
VDC
µA
VDC
VDC
mA
VDC
VDC
VDC
ELECTRICAL CHARACTERISTICS
TA = +25ºC
PARAMETER
CONDITIONS
Maximum Continuous Operating
Output Voltage
Maximum Load Current
25ºC
On Resistance – Maximum
25ºC
Typical Thermal Resistance, θJA
θJC
Turn-On Time, Maximum
Turn-Off Time, Maximum
Off State Leakage, 80 V
Dielectric Strength, Minimum
I/O, 60 Hz Sine Wave
Typical Isolation Resistance
Input to Case, 500 V
53024
60
1.0
0.35
120
30
3.0
3.0
100
1000
109
UNITS
VDC
A
Ohms
ºC/W
ms
ms
µA
V RMS
Ohms
Micropac Industries cannot assume any responsibility for any circuits shown or represent that they are free from patent infringement.
Micropac reserves the right to make changes at any time in order to improve design and to supply the best product possible.
MICROPAC INDUSTRIES, INC. HYBRID MICROELECTRONICS PRODUCTS DIVISION • 905 E. Walnut St., Garland, TX 75040 • (972) 272-3571 • Fax (972) 494-2281
|