|
Unisonic Technologies |
UNISONIC TECHNOLOGIES CO., LTD
LR1965
Preliminary
1.5A, LOW DROPOUT
REGULATOR WITH POWER
GOOD
CMOS IC
DESCRIPTION
The UTC LR1965 is CMOS-based positive voltage and a very
low dropout regulator IC that minimum input voltage is 2.5V and is
capable of delivering the continuous output load current up to 1.5A.
It has features of low dropout (maximum 300mV at 1A), a very
low quiescent current (typically 300uA at 0.1A) and very high
PSRR up to 86dB at 1A load current.
The output voltage can be set from 0.5V to (VIN - VDRP) with
an external resistor divider and it has ±2% accuracy through all
temperature ranges include the line as well as load variations. It is
allowed to use a small 4.7μF MLCC input and output capacitor to
deliver the current with the stable operation.
Built-in Soft-Start function reduces the inrush current and the
other features are include over current protection (OCP),
short-circuit protection (SCP), and thermal shut down protection
(TSD).
The UTC LR1965 is available in 8-SOP-EP package with
exposed pad for optimal power dissipation and 8-TDFN (3x3mm).
FEATURES
* Input Voltage Range: 2.5V~6.0V
* Supply Current .: Typ. 300uA
* Current limit : Min. 1.8A
* Adjustable Output from 0.8V
* LR1965: Typ 0.4V Dropout @ IOUT=1.5A
* Compatible with MLCC Capacitors
* Built-in Soft-Start Limits Inrush Current
* Built-in Thermal Shutdown Protection
* Built-in Over Current & Short Circuit Protection
HSOP-8
ORDERING INFORMATION
Ordering Number
LR1965G-xx-SH2-R
Note: xx: Output Voltage, refer to Marking Information.
Package
HSOP-8
LR1965G-xx-SH2-R
(1)Packing Type
(2)Package Type
(3)Output Voltage Code
(4)Green Package
(1) R: Tape Reel
(2) SH2: HSOP-8
(3) xx: refer to Marking Information
(4) G: Halogen Free and Lead Free
Packing
Tape Reel
www.unisonic.com.tw
Copyright © 2015 Unisonic Technologies Co., Ltd
1 of 4
QW-R102-066.a
LR1965
MARKING INFORMATION
PACKAGE
VOLTAGE CODE
Preliminary
MARKING
HSOP-8
AD: ADJ
PIN CONFIGURATION
CMOS IC
PIN DESCRIPTION
PIN NO.
1, 2
3
4
5
6
7, 8
PIN NAME
OUT
FB
GND
PG
EN
VIN
DESCRIPTION
Voltage Regulator Output Pin
Feedback Pin. Connect to output through a voltage-divider to set the output.
Recommended that the tolerance of feedback resistors is below 1%.
Ground Pin
Open Drain Power-Good (PG) Output.
Chip Enable Pin
Input Supply Voltage Pin.
BLOCK DIAGRAM
VIN
EN
GND
Reference
(0.5V)
Error
AMP
OCP/TSD
Power Good
Control
OUT
FB
PG
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
2 of 4
QW-R102-066.a
|