|
|
PDF QN8035 Data sheet ( Hoja de datos )
| Número de pieza | QN8035 | |
| Descripción | Single-Chip Low-Power FM Receiver | |
| Fabricantes | Quintic | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de QN8035 (archivo pdf) en la parte inferior de esta página. Total 39 Páginas | ||
|
No Preview Available !
QN8035
Single-Chip Low-Power FM Receiver for Portable Devices
Preliminary
________ General Description ________ _________Typical Applications________
The QN8035 is a high performance, low power; full-
featured single-chip stereo FM receiver designed for cell
phones, MP3 players. The QN8035 also supports
RDS/RBDS data reception.
• Cell Phones / PDAs / Smart Phones
• Portable Audio & Media Players
• MP3/MP4 player, PMP, PND
_______________________________ Key Features ___________________________
• Worldwide FM Band Coverage
• 60 MHz to 108 MHz full band tuning in
50/100/200 kHz step sizes
• 50/75µs de-emphasis
• Ease of Integration
• Small footprint, available in 2.5 x2.5 QFN16 and
3x3 MSOP10 packages
• 32.768 kHz and multiple MHz clocks input
• I2C control interface
• Very Low Power Consumption
• 13 mA typical
• VCC: 2.7~5.0V, indegrated LDO, support battery
direct connection
• Power saving Standby mode
• Low shutdown leakage current
• Accommodate 1.6~3.6V digital interface
• Adaptive Noise Cancellation
• Volume Control
• High Performance
• Superior sensitivity, better than 1.5 µVEMF
• 63dB stereo SNR, 0.03% THD
• Integrated adaptive noise cancellation (SNC, HCC,
SM)
• Improved auto channel seek
• L/R separation 45dB
• RDS/RBDS
1. Supports US and European data services
• Superior sensitivity, better than 8.9 µVEMF
• Robust Operation
• -250C to +850C operation
• ESD protection on all input and output pads
QN8035 Functional Blocks:
RX ANT
RFI
2.7–5.0V VCC
10µF
Voltage
Regulator
Tune
De
Mod
De
MPX
De
Emph
ARO
ALO
RDS
PHY
DSP FSM
Control Interface
XCLK
Ordering Information appears at Section 7.
SDA
SCL
I2C Controller
INT
Rev 0.08 (02/10)
Copyright ©2010 by Quintic Corporation
Page 1
Confidential A
Confidential Information contained herein is covered under Non-Disclosure Agreement (NDA).
Advance Technical Information. This is a product under development. Characteristics and specifications are subject to change without notice..
Free Datasheet http://www.datasheet4u.com/
1 page  
2 ELECTRICAL SPECIFICATIONS
Table 2: Absolute Maximum Ratings
SYMBOL
PARAMETER
Vbat Supply voltage
VIO Logic signal level
Ts Storage temperature
CONDITIONS
VCC to GND
CEN, SCL, SDA, INT
to GND
MIN
-0.3
-0.3
-55
QN8035
MAX
5
3.6
+150
UNIT
V
V
oC
Table 3: Recommended Operating Conditions
SYMBOL
PARAMETER
CONDITIONS
Vcc Supply voltage
VCC to GND
TA Operating temperature
RFin RF input level1
VIO Digital I/O voltage
Notes:
1. At RF input pin, RFI.
Peak input voltage
MIN
2.7
-25
1.6
TYP
3.3
MAX
5.0
+85
0.3
3.6
UNIT
V
oC
V
V
Rev 0.08 (02/10)
Copyright ©2010 by Quintic Corporation
Page 5
Confidential A
Confidential Information contained herein is covered under Non-Disclosure Agreement (NDA).
Advance Technical Information. This is a product under development. Characteristics and specifications are subject to change without notice.
Free Datasheet http://www.datasheet4u.com/
5 Page 
QN8035
The following figure is measured at FM=88MHz. The RSSI Curve is not varied by FM frequency.
Figure 5 RSSI vs RF Input
3.2 Audio Processing
The MPX signal after FM demodulation is comprised of
left and right channel signal, pilot and RDS signal in the
following way:
m(t) = [L(t) + R(t)] + [L(t) − R(t)]sin(4π ft + 2θ0 ) + α sin(2π ft +θ0 ) + d (t) sin(6π ft + 3θ0 )
Here, L(t) and R(t) correspond to the audio signals on the
left and right channels respectively, f = 19 kHz, θ is the
initial phase of pilot tone and α is the magnitude of the
pilot tone, and d(t) is the RDS signal. In stereo mode,
both L and R are recovered by de-MPX. In mono mode,
only the L+R portion of audio signal exists. L(t) and R(t)
are recovered by de-MPX.
In receive mode, stereo noise cancellation (SNC) for FM
only, high cut control (HCC) and soft mute (SM) are
supported. Stereo noise suppression is achieved by
gradually combining the left and right signals to be a
mono signal as the received signal quality degrades.
SNC, HCC and SM are controlled by SNR and multipath
channel estimation results. The three functions will be
archived automatically in the device.
The QN8035 has an integrated mono or stereo audio
status indicator. There is also a Read ST_MO_RX
(Reg04h [0]) bit to get sound information. In addition,
there also is a force mono function to constrain output
mono in Reg04h.
To improve the signal-to-noise ratio of the FM receiver
by reducing the effect of high frequency interference and
noise, the device integrates a technique known as de-
emphasis. There are two selectable time constants (75us
and 50us) supported.
Rev 0.08 (02/10)
Copyright ©2010 by Quintic Corporation
Page 11
Confidential A
Confidential Information contained herein is covered under Non-Disclosure Agreement (NDA).
Advance Technical Information. This is a product under development. Characteristics and specifications are subject to change without notice.
Free Datasheet http://www.datasheet4u.com/
11 Page | ||
| Páginas | Total 39 Páginas | |
| PDF Descargar | [ Datasheet QN8035.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| QN8035 | Single-Chip Low-Power FM Receiver | Quintic |
| QN8036 | High Performance Digital FM Transceiver | Quintic |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |