|
|
PDF RX-4100 Data sheet ( Hoja de datos )
| Número de pieza | RX-4100 | |
| Descripción | AM/FM Stereo Receiver | |
| Fabricantes | Sherwood | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de RX-4100 (archivo pdf) en la parte inferior de esta página. Total 17 Páginas | ||
|
No Preview Available !
OPERATINGINSTRUCTIONS
STANDBY
AM/FM STEREO RECEIVER RX-4100
MEMORY T/P MODE
TUNING/PRESET
REMOTE
SENSOR
ON/STANDBY
PHONES
A SPEAKER B
FM/AM
CD
TAPE
TV/AUX
DA S
DISCRETE AMPLIFIER STAGE
TONE BALANCE
VCR
TONE DIRECT
VOLUME
RX-4100
AM/FM STEREO RECEIVER
1 page  
System Connections
Do not plug the AC input cord into the wall AC outlet until all connections are completed.
Be sure to connect the white RCA pin cord to the L(left) and the red RCA pin cord to the R(right) jacks when making audio
connections.
Change the position of the FM indoor antenna until you get the best reception of your favorite FM stations.
A 75 Ω outdoor FM antenna may be used to further improve the reception.
Disconnect the indoor antenna before replacing it with the outdoor one.
Place the AM loop antenna as far as possible from the receiver, TV set, speaker cords and the AC input cord and set it to a
direction for the best reception.
If the reception is poor with the AM loop antenna, an AM outdoor antenna can be used in place of the AM loop antenna.
Make connections firmly and correctly. If not, it can cause loss of sound, noise or damage to the receiver.
If the electricity fails or the AC input cord is left unplugged for more than 2 weeks, the memorized contents will be cleared.
Should this happen, memorize them again.
ANTENNA
CD TV/AUX
TAPE
IN OUT
VCR
IN OUT
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received,
including interference that may cause undesired operation.
SPEAKERS
SPEAKER IMPEDANCE
A, B - 8 MIN / SPEAKERS
A+B -16 MIN / SPEAKERS
MODEL NO. RX-4100
STEREO RECEIVER
SER. NO
MADE IN CHINA
DESIGNED IN USA
AC INPUT
120V~60Hz
2.5A
■ CONNECTING ANTENNAS
FM
(OUTDOOR ANTENNA)
FM
(INDOOR ANTENNA)
AM loop antenna
AM
LOOP
■ CONNECTING AUDIO/VIDEO COMPONENTS
CD player
MULTIPLE COMPACT DISC PLAYER CDC-5080R
POWER
ON/OFF
V-CD PBC REVERT PROG AUTO
GRAPHICS PEAK DELETE EDIT
AB
12345
RANDOM REPEAT ALL 1 DISC S 1
SCENE TRACK
A< >B MPX INTRO 4
INDEX STEP
7
10
13
23
56
89
11 12
14 15
REMOTE SENSOR
PROGRAM/REVIEW RANDOM REPEAT
OPEN/CLOSE
PHONES LEVEL
MIN MAX
PHONES
AUDIO OUT
TV or additional component
CD TV/AUX
TAPE
IN OUT
VCR
IN OUT
Tape deck
DIGI-LINK STEREO DOUBLE CASSETTE DECK DD-5080C
BC
HIGH NORM
CD SYN MPX
REC
MIN
M
SEC
RELAY P
REC
L
dB -00
R
-20
-10
-6
-3
0 +3 +6
COUNTER
RESET
A/B
MODE
T SIZE MEMORY B/C/OFF
R PLAY
REVERSE
AUTO REVERSE
PLAY/AUTO TAPE SELECTOR
B
EJECT
DUBBING
NORMAL
HIGH
AMS
O/O
CD SUN REC
AMS
AUTO REVERSE
HX-PRO
A RECORD & PLAY/AUTO TAPE SELECTOR
POWER
PHONES
REC LEVEL
REC BALANCE
MIC MIX
MIC
0 10 L
R SOURCE
MIC
PLAY(LINE) OUT
REC(LINE) IN
Video deck or MD recorder, etc.
POWER
ON/OFF
MULTIPLE COMPACT DISC PLAYER CDC-5080R
OPEN/CLOSE
PHONES LEVEL
MIN
MAX
V-CD PBC REVERT PROG AUTO
GRAPHICS
PEAK DELETE EDIT
AB
12345
RANDOM REPEAT ALL 1 DISC S 1
SCENE TRACK
A< >B MPX INTRO 4
INDEX STEP
7
10
13
23
56
89
11 12
14 15
PHONES
AUDIO OUT
AUDIO IN
• The VCR jacks may also be connected to an additional
component such as MD recorder, tape deck, etc.
• The TV/AUX jacks may also be connected to an additional
component such as a TV, DVD player, etc.
5
5 Page 
Adjusting the tone(bass and treble)
8
Enter the tone mode.
TONE
or
POWER
A SPEAKER B
1 234
5 678
9 0 FM MODE MEMORY
DISPLAY SLEEP P.SCAN TUNER
CD
TAPE
VCR
AUX
AUDIO CONTROL TONE SEL
TREBLE
BALANCE /BASS MUTE VOLUME
REMOTE CONTROL UNIT RM-101
TONE SEL
At the desired tone mode, adjust the tone as
9 desired.
or
TREBLE
/BASS
POWER
A SPEAKER B
1 234
5 678
9 0 FM MODE MEMORY
DISPLAY SLEEP P.SCAN TUNER
CD TAPE VCR AUX
AUDIO CONTROL TONE SEL
TREBLE
BALANCE /BASS MUTE VOLUME
REMOTE CONTROL UNIT RM-101
Each time this button is pressed, the corresponding
tone mode is selected and shown for 5 seconds as
follows:
BAS(s) TRE(ble)
Note:
When the tone direct function is activated, the tone
mode cannot be entered and “T-DIR” is displayed.
If the tone display disappears, start from the step 8
again.
Notes:
Extreme settings at high volume may damage your
speakers.
In general, the bass and treble levels are adjusted
to 0.
To listen to a program source without the tone effect.
TONE DIRECT
“T-DIR” is displayed and the sound that bypasses
the tone circuitry will be heard.
To cancel the tone direct function, press this button
again to display “D-OFF”.
Adjusting the sound volume balance
Enter the balance mode.
BALANCE
Adjust the sound volume balance between
the left and right speakers.
or
BALANCE
POWER
A SPEAKER B
1 234
5 678
9 0 FM MODE MEMORY
DISPLAY SLEEP P.SCAN TUNER
CD TAPE VCR AUX
AUDIO CONTROL TONE SEL
TREBLE
BALANCE /BASS MUTE VOLUME
REMOTE CONTROL UNIT RM-101
“BAL” is displayed for 5 seconds.
If the balance display disappears, start from the
step 11 again.
When the BALANCE + / - buttons on the remote
control are pressed, it enters the balance mode
automatically without pressing the BALANCE
button on the front panel.
Note:
In general, the balance level is set to the center
position(red dot).
11
11 Page | ||
| Páginas | Total 17 Páginas | |
| PDF Descargar | [ Datasheet RX-4100.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| RX-4100 | AM/FM Stereo Receiver | Sherwood |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |