DataSheet.es    


PDF NL10276BC20-10 Data sheet ( Hoja de datos )

Número de pieza NL10276BC20-10
Descripción TFT COLOR LCD MODULE
Fabricantes NEC 
Logotipo NEC Logotipo



Hay una vista previa y un enlace de descarga de NL10276BC20-10 (archivo pdf) en la parte inferior de esta página.


Total 33 Páginas

No Preview Available ! NL10276BC20-10 Hoja de datos, Descripción, Manual

TFT COLOR LCD MODULE
NL10276BC20-10
26cm (10.4 Type)
XGA
LVDS interface (1port)
DATA SHEET
DOD-PP-0994 (1st edition)
This PRELIMINARY DATA SHEET is updated
document from DOD-PP-0888(5).
All information is subject to change without notice.
Please confirm the sales representative before
starting to design your system.
Document Number: DOD-PP-0994 (1st edition)
Published date: May 2010 CP(N)
1 © NEC LCD Technologies, Ltd.
2010 All rights reserved.

1 page




NL10276BC20-10 pdf
NL10276BC20-10
2. GENERAL SPECIFICATIONS
Display area
Diagonal size of display
Drive system
Display color
Pixel
Pixel arrangement
Dot pitch
Pixel pitch
Module size
Weight
Contrast ratio
Viewing angle
Designed viewing direction
Polarizer surface
Polarizer pencil-hardness
Color gamut
Response time
Luminance
Reflection ratio
Signal system
Power supply voltage
210.432 (H) × 157.824 (V) mm
26cm (10.4 inches)
a-Si TFT active matrix
16,777,216 colors (At 8-bit input, FRC terminal= High)
262,144 colors (At 6-bit input, FRC terminal= Low or Open)
1,024 (H) × 768 (V) pixels
RGB (Red dot, Green dot, Blue dot) vertical stripe
0.0685 (H) × 0.2055 (V) mm
0.2055 (H) × 0.2055 (V) mm
228.0 (W) × 178.5 (H) × 8.7 (D) mm (typ.)
380 g (typ.)
At transmissive mode, IL= 40mA/One circuit
150:1 (typ.)
At reflective mode
15:1 (typ.)
At the contrast ratio 10:1
Horizontal: Right side 20° (typ.), Left side 25° (typ.)
Vertical: Up side 25° (typ.), Down side 20° (typ.)
At DPS= Low or Open: Normal scan
Viewing direction without image reversal: Down side (6 o'clock)
Viewing direction with contrast peak: Up side (12 o'clock)
Viewing angle with optimum grayscale (γ2.2): Normal axis
(perpendicular)
Clear
3H (min.) [by JIS K5400]
At transmissive mode, LCD panel center
40 % (typ.) [against NTSC color space]
Ton+Toff (10%←→ 90%)
30 ms (typ.)
At IL= 40mA/One circuit
175 cd/m2 (typ.)
At reflective mode
35 % (typ.)
LVDS 1port
(Receiver: THC63LVDF84B, THine Electronics Inc. or equivalent)
8bit/6bit digital signals for data of RGB colors, Dot clock (CLK),
Data enable (DE)
LCD panel signal processing board: 3.3V
LED backlight type:
Backlight
Replaceable part
Lamp holder set: Type No. 104LHS50
Power consumption
At IL= 40mA/One circuit, Checkered flag pattern
5.9 W (typ.)
DATA SHEET DOD-PP-0994 (1st edition)
5

5 Page





NL10276BC20-10 arduino
4.4 POWER SUPPLY VOLTAGE SEQUENCE
4.4.1 LCD panel signal processing board
VCC
Note1
0V
ON
3.0V
10μs Tr < 50ms
Display signals*
Function signals
Note2
0V
0ms < t < 35ms
VALID period
NL10276BC20-10
OFF
ON
0.3V
Toff 50ms
0ms < t < 35ms
* These signals should be measured at the terminal of 100Ω resistance.
Note1: If there is a voltage variation (voltage drop) at the rising edge of VCC below 3.0V, there is a
possibility that a product does not work due to a protection circuit.
Note2: Display signals (D0+/-, D1+/-, D2+/-, D3+/-, CLK+/-) and function signals (DPS, FRC, MSL)
must be set to Low or High-impedance, except the VALID period (See above sequence
diagram), in order to avoid the circuitry damage.
If some of display and function signals of this product are cut while this product is working,
even if the signal input to it once again, it might not work normally. If a customer stops the
display and function signals, VCC also must be shut down.
4.4.2 LED Driver board
Display and
function signals
Note1
Note2
VALID period
LED backlight: ON
Note1: These are the display and function signals for LCD panel signal processing board.
Note2: The backlight should be turned on within the valid period of display and function signals, in
order to avoid unstable data display.
DATA SHEET DOD-PP-0994 (1st edition)
11

11 Page







PáginasTotal 33 Páginas
PDF Descargar[ Datasheet NL10276BC20-10.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
NL10276BC20-10TFT COLOR LCD MODULENEC
NEC
NL10276BC20-12TFT Color LCD ModuleNEC
NEC
NL10276BC20-18Display ModuleNEC
NEC
NL10276BC20-18CTFT Color LCD ModuleNLT
NLT

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar