|
|
PDF NL10276BC30-18 Data sheet ( Hoja de datos )
| Número de pieza | NL10276BC30-18 | |
| Descripción | LCD Module | |
| Fabricantes | NEC | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de NL10276BC30-18 (archivo pdf) en la parte inferior de esta página. Total 29 Páginas | ||
|
No Preview Available !
www.DataSheet4U.net
TFT COLOR LCD MODULE
NL10276BC30-18
38cm (15.0 Type)
XGA
LVDS Interface (1port)
PRELIMINARY DATA SHEET
DOD-PD-1038 (1st edition)
All information is subject to change without notice.
Please confirm the sales representative before
starting to design your system.
Document Number: DOD-PD-1038 (1st edition)
Published date: June 2005 CP(N)
1 © NEC LCD Technwowlowg.Dieatsa,ShLetedt4.U.net
2005 All rights reserved.
1 page  
www.DataSheet4U.net
NL10276BC30-18
2. GENERAL SPECIFICATIONS
Display area
Diagonal size of display
Drive system
Display color
Pixel
Pixel arrangement
Dot pitch
Pixel pitch
Module size
Weight
Contrast ratio
Viewing angle
Designed viewing direction
Polarizer surface
Polarizer pencil-hardness
304.128 (H) × 228.096 (V) mm
38cm (15.0 inches)
a-Si TFT active matrix
16,777,216 colors (6bit+FRC)
1,024 (H) × 768 (V) pixels
RGB (Red dot, Green dot, Blue dot) vertical stripe
0.099 (H) × 0.297 (V) mm
0.297 (H) × 0.297 (V) mm
326.5 (typ., W) × 253.5 (typ., H) × 17.0 (max., D) mm
1,300g (typ.)
400:1 (typ.)
At the contrast ratio ≥ 10:1
• Horizontal: Right side 75° (typ.), Left side 75° (typ.)
• Vertical: Up side 75° (typ.), Down side 55° (typ.)
At DPS terminal= Low or Open: Normal scan
• Viewing direction without image reversal: up side (12 o'clock)
• Viewing direction with contrast peak: down side (6 o'clock)
• Viewing angle with optimum grayscale (γ=2.2): normal axis (perpendicular)
Antiglare
3H (min.) [by JIS K5400]
Color gamut
At LCD panel center
40% (typ.) [against NTSC color space]
Response time
Ton+Toff (10%←→ 90%)
TBD ms (typ.)
Luminance
At IBL=6.0mArms / lamp
500cd/m2 (typ.)
Signal system
LVDS 1port (Receiver: Equivalent of THC63LVDF84A, THine Electronics Inc.)
[8-bit digital signals for data of RGB colors, Dot clock (CLK),
Data enable (DE)]
Power supply voltage
LCD panel signal processing board: 3.3V
Edge light type: 4 cold cathode fluorescent lamps (without inverter)
Backlight
Replaceable part
• Lamp holder set: Type No. TBD
Power consumption
Recommended inverter (Option)
• Inverter: Type No. 150PW231
At IBL= 6.0mArms / lamp, Checkered flag pattern
TBD W (typ., Power dissipation of the inverter is not included.)
PRELIMINARY DATA SHEET DOD-PD-1038 (1st edition)
www.DataSh5eet4U.net
5 Page 
www.DataSheet4U.net
NL10276BC30-18
4.4 POWER SUPPLY VOLTAGE SEQUENCE
ON
VCC
3.0V
Note1
0V
0.1ms < Tr < 80ms
OFF
ON
2.5V 3.0V
20ms max.
Toff > 200ms
Display signals*,
Function signals
Note2
0V
VALID period
35ms < t < 50ms
10ms < t < 35ms
* These signals should be measured at the terminal of 100Ω resistance.
Note1: In terms of voltage variation (voltage drop) while VCC rising edge is below 3.0V, a
protection circuit may work, and then this product may not work.
Note2: Display signals (D0+/-, D1+/-, D2+/-, D3+/- and CK+/-) and function signals (MSL and
DPS) must be Low or High impedance, exclude the VALID period (See above sequence
diagram), in order to avoid that internal circuit is damaged.
If some of display and function signals of this product are cut while this product is working,
even if the signal input to it once again, it might not work normally. VCC should be cut
when the display and function signals are stopped.
Note4: The backlight power supply voltage should be inputted within the valid period of display
and function signals, in order to avoid unstable data display.
PRELIMINARY DATA SHEET DOD-PD-1038 (1st edition)
www.DataSh1e1et4U.net
11 Page | ||
| Páginas | Total 29 Páginas | |
| PDF Descargar | [ Datasheet NL10276BC30-18.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| NL10276BC30-10 | TFT COLOR LCD MODULE | NEC |
| NL10276BC30-15 | Display Module | NEC |
| NL10276BC30-17 | Display Module | NEC |
| NL10276BC30-18 | LCD Module | NEC |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |