|
NXP Semiconductors |
INTEGRATED CIRCUITS
DATA SHEET
74AHC573; 74AHCT573
Octal D-type transparent latch;
3-state
Product specification
File under Integrated Circuits, IC06
1999 Sep 27
Philips Semiconductors
Octal D-type transparent latch; 3-state
Product specification
74AHC573; 74AHCT573
FEATURES
• ESD protection:
HBM EIA/JESD22-A114-A
exceeds 2000 V
MM EIA/JESD22-A115-A
exceeds 200 V
CDM EIA/JESD22-C101
exceeds 1000 V
• Balanced propagation delays
• All inputs have Schmitt-trigger
actions
• Common 3-state output enable
input
• Functionally identical to the ‘563’
and ‘373’
• Inputs accepts voltages higher than
VCC
• For AHC only:
operates with CMOS input levels
• For AHCT only:
operates with TTL input levels
• Specified from
−40 to +85 and +125 °C.
DESCRIPTION
The 74AHC/AHCT573 are high-speed Si-gate CMOS devices and are pin
compatible with low power Schottky TTL (LSTTL). They are specified in
compliance with JEDEC standard No. 7A.
The 74AHC/AHCT573 are octal D-type transparent latches featuring separate
D-type inputs for each latch and 3-state outputs for bus oriented applications.
A Latch Enable (LE) input and an Output Enable (OE) input are common to all
latches.
The ‘573’ consists of eight D-type transparent latches with 3-state true outputs.
When LE is HIGH, data at the Dn inputs enters the latches. In this condition the
latches are transparent, i.e. a latch output will change state each time its
corresponding D-input changes.
When LE is LOW the latches store the information that was present at the
D-inputs a set-up time preceding the HIGH-to-LOW transition of LE. When OE
is LOW, the contents of the 8 latches are available at the outputs. When OE is
HIGH, the outputs go to the high-impedance OFF-state. Operation of the OE
input does not affect the state of the latches.
The ‘573’ is functionally identical to the ‘533’, ‘563’ and ‘373’, but the ‘533’ and
‘563’ have inverted outputs and the ‘563’ and ‘373’ have a different pin
arrangement.
QUICK REFERENCE DATA
GND = 0 V; Tamb = 25 °C; tr = tf ≤ 3.0 ns.
SYMBOL
PARAMETER
CONDITIONS
tPHL/tPLH
CI
CO
CPD
propagation delay
Dn to Qn; LE to Qn
input capacitance
output capacitance
power dissipation
capacitance
CL = 15 pF; VCC = 5 V
VI = VCC or GND
CL = 50 pF; f = 1 MHz;
notes 1 and 2
Notes
1. CPD is used to determine the dynamic power dissipation (PD in µW).
PD = CPD × VCC2 × fi + ∑ (CL × VCC2 × fo) where:
fi = input frequency in MHz;
fo = output frequency in MHz;
∑ (CL × VCC2 × fo) = sum of outputs;
CL = output load capacitance in pF;
VCC = supply voltage in Volts.
2. The condition is VI = GND to VCC.
TYPICAL
AHC
4.2
AHCT
3.9
3.0 3.0
4.0 4.0
12 18
UNIT
ns
pF
pF
pF
1999 Sep 27
2
|