DataSheet.es    


PDF HSD096MS11-B00 Data sheet ( Hoja de datos )

Número de pieza HSD096MS11-B00
Descripción Display Module
Fabricantes HannStar 
Logotipo HannStar Logotipo



Hay una vista previa y un enlace de descarga de HSD096MS11-B00 (archivo pdf) en la parte inferior de esta página.


Total 24 Páginas

No Preview Available ! HSD096MS11-B00 Hoja de datos, Descripción, Manual

Document Title
Document No.
HannStar Display Corp.
HSD096MS11 Product Information
Page No.
Revision
1 / 24
1.0
Product Information
Model: HSD096MS11
-B00
Note : 1. Please contact HannStar Display Corp. before designing your product based on this module
specification.
2. The information contained herein is presented merely to indicate the characteristics and performance
of our products. No responsibility is assumed by HannStar for any intellectual property claims or
other problems that may result from application based on the module described herein.
The information contained in this document is the exclusive property of HannStar Display Corporation. It shall not be
disclosed, distributed or reproduced in whole or in part without written permission of HannStar Display Corporation.
http://www.Datasheet4U.com

1 page




HSD096MS11-B00 pdf
Document Title
Document No.
HannStar Display Corp.
HSD096MS11 Product Information
Page No.
Revision
5 / 24
1.0
2.0 ABSOLUTE MAXIMUM RATINGS
2.1 Absolute Rating of Environment
Item
Symbol
Min. Max. Unit Note
Storage temperature
TSTG
-20 60 oC
Operating temperature
TOPR
0 50 oC
Vibration(non-operating)
Vnop 1.5 G (1)
Shock(non-operating)
Snop 70 G (2)
Storage humidity
HSTG
10 90 %RH (3)
Operating humidity
HOP 10 80 %RH (3)
Note (1) 10-300 Hz, sine wave, 30min/cycle, X/Y/Z each one cycle except for resonant
frequency.
(2) 11ms/±X,±Y,±Z direction, half-sine wave.
(3) Max wet bulb temp =39oC
2.2 Electrical Absolute Rating
2.2.1 TFT LCD Module
Item
Power supply voltage
Logic input voltage
Symbol
VDD
VIN
Min. Max. Unit
-0.3 4.0
V
-0.3 VDD+0.3
V
Note
(1)
(1)
2.2.2
Back-Light Unit
Item
Lamp voltage
Lamp current
Lamp frequency
Symbol
Min.
Max.
Unit
Note
VL
0
2000
Vrms
(1)
IL 2.0 7.0 mA (1)
fL 50 80 kHz (1)
Note (1) Permanent damage may occur to the LCD module if beyond this specification.
Functional operation should be restricted to the conditions described under
normally operating conditions.
The information contained in this document is the exclusive property of HannStar Display Corporation. It shall not be
disclosed, distributed or reproduced in whole or in part without written permission of HannStar Display Corporation.
http://www.Datasheet4U.com

5 Page





HSD096MS11-B00 arduino
Document Title
Document No.
HannStar Display Corp.
HSD096MS11 Product Information
Page No.
Revision
11 / 24
1.0
4.2 Back-Light Unit
The back-light system is an edge-lighting type with 2 CCFL(Cold Cathode Fluorescent Lamp).
The characteristics of the lamp are shown in the following tables.
Single CCFL, Side-light type
Item Symbol Min. Typ. Max. Unit Note
Lamp current
IL 2.0 6.0 7.0 mA(rms) (1)
Lamp voltage
VL - 500 - V(rms) IL=6.0mA
Frequency
fL 50 55 80 KHz (2)
Operating life time
Hr 40,000
-
-
Hours
(3)
Startup voltage
Vs -
-
1032
1344
V(rms)
at 25oC
at 0oC
Note (1) Lamp current is measured with current meter for high frequency as shown below.
Specified valued are for a lamp.
LCD MODULE
WHITE (GND)
BLUE
WHITE (GND)
RED
2
1
2
1
A
A
INVERTER
Note (2) Lamp frequency may produce interference with horizontal synchronous
frequency and this may cause line flow on the display. Therefore lamp
frequency shall be detached from the horizontal synchronous frequency
and its harmonics as far as possible in order to avoid interference.
Note (3) Life time (Hr) can be defined as the time in which it continues to operate
under the condition : Ta=25~35oC, IL=6.0mA(Typ.) until one of the
following event occurs :
1. When the brightness becomes 50%
2.When the effective ignition length becomes 90%
Note (4) Max. startup voltage shall be defined as max. voltage which CCFL can be
startup. When the customer selects the inverter, the min. value of startup
voltage must be high than CCFL's max. startup voltage.
The information contained in this document is the exclusive property of HannStar Display Corporation. It shall not be
disclosed, distributed or reproduced in whole or in part without written permission of HannStar Display Corporation.
http://www.Datasheet4U.com

11 Page







PáginasTotal 24 Páginas
PDF Descargar[ Datasheet HSD096MS11-B00.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
HSD096MS11-B00Display ModuleHannStar
HannStar

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar