|
|
PDF VX1935wm-1 Data sheet ( Hoja de datos )
| Número de pieza | VX1935wm-1 | |
| Descripción | TFT LCD Display Manual | |
| Fabricantes | ViewSonic | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de VX1935wm-1 (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
|
No Preview Available !
Service Manual
ViewSonic VX1935wm-1
Model No. VS11307
19” Color TFT LCD Display
(VX1935wm-1_SM Rev. 1a Sep. 2006)
ViewSonic 381 Brea Canyon Road, Walnut, California 91789 USA - (800) 888-8583
1 page  
5. LCD Module Handling Precautions
5.1. Handling Precautions
(1) Since front polarizer is easily damaged, pay attention not to scratch it.
(2) Be sure to turn off power supply when inserting or disconnecting from input
connector.
(3) Wipe off water drop immediately. Long contact with water may cause discoloration or
spots.
(4) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
(5) Since the panel is made of glass, it may break or crack if dropped or bumped on hard
surface.
(6) Since CMOS LSI is used in this module, take care of static electricity and insure
human earth when handling.
(7) Do not open nor modify the Module Assembly.
(8) Do not press the reflector sheet at the back of the module to any directions.
(9) In case if a Module has to be put back into the packing container slot after once it was
taken out from the container, do not press the center of the CCFL Reflector edge.
Instead, press at the far ends of the CFL Reflector edge softly. Otherwise the TFT
Module may be damaged.
(10) At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor
tilt the Interface Connector of the TFT Module.
(11) After installation of the TFT Module into an enclosure (LCD monitor housing, for
example),
do not twist nor bend the TFT Module even momentary. At designing the enclosure, it
should be taken into consideration that no bending/twisting forces are applied to the
TFT Module from outside. Otherwise the TFT Module may be damaged.
(12) Cold cathode fluorescent lamp in LCD contains a small amount of mercury. Please
follow local ordinances or regulations for disposal.
(13) Small amount of materials having no flammability grade is used in the LCD module.
The LCD module should be supplied by power complied with requirements of Limited
Power Source, or be applied exemption.
(14) The LCD module is designed so that the CFL in it is supplied by Limited Current
Circuit.
Do not connect the CFL in Hazardous Voltage Circuit.
ViewSonic Corporation
Confidential - Do Not Copy
2
VX1935wm-1
5 Page 
3. Front Panel Function Control Description
3.1 Short Cuts Function from the button(s)
[1] Main Menu
[2] Input toggle (Analog or Digital)
[▼] or [▲]
To immediately activate Brightness /Contrast menu.
Hot Keys for Function Controls
[▼]+ [▲]
Recall Contrast or Brightness while in the Contrast or
Brightness adjustment, or recall both of Contrast and
Brightness when the OSD is not on.
[1] + [2]
Toggle 720x400 and 640x400 mode when input 720x400
or 640x400 mode
[1] + [▼] + [▲]
White Balance. White Balance should set the screen on
(hold for 3 sec)
the pure black and white pattern with 640*480@60Hz
resolution.
[1] + [▼]
Power Lock (Unlock). User won’t be able to turn off the
(hold for 10 sec)
monitor.
[1] + [▲]
OSD Lock (Unlock). It will lock all functions.
(hold for 10 sec)
[2] + [ ]
Factory Mode (Press [ ] exit factory mode. )
with signal (hold for 3 sec) Inter Factory Mode adjust white balance and setting Burn
in Mode (On or Off) .
Remark : All the short cuts function are only available while OSD off
3.2 Front Panel Hardware Controls
Power Switch (Front Head)
Power LED (Front Head)
Front Panel Controls (Head)
[ 1 ] [ 2 ] [ ] [▼] [▲]
Reaction Time
Power Control, soft Power Switch.
Blue – ON
Orange – Active Off
Dark = Soft Power Switch OFF
[ 1 ] Button 1
[ 2 ] Button 2
[ ] Power
[▼] Down Arrow Button
[▲] Up Arrow Button
Note: Power Button, Button 1 and Button 2
must be one-shot logic operation. (i.e. there
should be no cycling)
OSD must fully appear within 0.5s after
pushing Button 1
ViewSonic Corporation
Confidential - Do Not Copy
8
VX1935wm-1
11 Page | ||
| Páginas | Total 30 Páginas | |
| PDF Descargar | [ Datasheet VX1935wm-1.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| VX1935wm-1 | TFT LCD Display Manual | ViewSonic |
| VX1935wm-3 | TFT LCD Display manual | ViewSonic |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |