|
|
PDF TB003 Data sheet ( Hoja de datos )
| Número de pieza | TB003 | |
| Descripción | An Introduction to KELLOQ Code Hopping | |
| Fabricantes | Microchip Technology | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de TB003 (archivo pdf) en la parte inferior de esta página. Total 12 Páginas | ||
|
No Preview Available !
TB003
An Introduction to KEELOQ® Code Hopping
Author: Kobus Marneweck
Microchip Technology Inc.
INTRODUCTION
Remote Control Systems
Remote control via RF or IR is popular for many appli-
cations, including vehicle alarms and automatic garage
doors. Conventional remote control systems are based
on unidirectional transmission and have limited secu-
rity. More sophisticated devices based on bi-directional
transmission are also available but, because of their
high cost and certain practical disadvantages, they are
not widely used in commercial remote control devices.
The popular unidirectional transmission systems cur-
rently have two very important security shortcomings:
the codes they transmit are usually fixed and the num-
ber of possible code combinations is relatively small.
Either of these shortcomings can lead to unauthorized
access.
Code Scanning
The limited number of possible combinations available in
most remote control systems makes it possible to trans-
mit all possible combinations in a relatively short time. A
hand held microprocessor-based system for this pur-
pose (called a code scanner) can easily be constructed.
www.DataSheeInt4Us.ycsotmems using eight DIP switches (256 combina-
tions), this scanning process can typically be accom-
plished in less than 32 seconds (when trying eight
combinations per second). Even in systems using
16-bit keys (yielding roughly 65,000 combinations),
only 2.25 hours would be required to try all possible
combinations. It should also be noted that the scanner
may gain access in far less than this maximum time—
the average time would in fact be half of the total time.
Scanning is counteracted by increasing the number of
possible code combinations. A 66-bit code will yield
7.3 x 1019 combination and will take 2.3 x 1011 years to
scan.
Code Grabbing
A remote control transmitter of the type normally used
in vehicle security systems, is nothing but a small radio
transmitter that transmits a code number on a certain
frequency. This code number is normally generated by
an integrated circuit encoder. The transmit frequency is
normally fixed by legislation within a particular country,
enabling anybody to build a simple receiver that can
receive signals from all such transmitters.
It is a simple matter to build a circuit to record such
transmissions captured by the receiver. Such a device
is known as a code or key grabber. A would-be vehicle
thief would typically lurk in a parking lot, waiting until a
vehicle owner arms his alarm with a remote control.
The key grabber would capture the transmitted code,
enabling the thief to retransmit this code as soon as the
owner leaves the parking lot. Typically, this would leave
the alarm and/or immobilizer disabled and even the
central locking unlocked.
The Solution
It is apparent that secure remote control systems can
only be implemented if two conditions are met. The
KEELOQ® code hopping system meets both these con-
ditions with ease.
• A large number of possible combinations must be
available.
A 66-bit transmission code is used to make scan-
ning impossible. The 32-bit encrypted portion pro-
vides for more than 4 billion code combinations. A
complete scan would take 17 years! If the 34-bit
fixed portion is taken into account, the time
required for a complete scan jumps to 5,600 bil-
lion years!
• The system may never respond twice to the same
transmitted code.
The random code algorithm will never respond to
the same code twice over several lifetimes of a
typical system.
Every time a remote control button is pushed, the sys-
tem will transmit a different code. These codes appear
random to an outsider – there is no apparent relation-
ship between any code and the previous or next code.
A far easier way of gaining unauthorized access to a
security system is freely available—such a unit is being
advertised as a tool for the “legal repossession of vehi-
cles.” To understand its operation, it is useful to know
something about remote controls.
KEELOQ is a registered trademark of Microchip Technology, Inc.
Microchip’s Secure Data Products are covered by some or all of the following patents:
Code hopping encoder patents issued in Europe, U.S.A., and R.S.A. — U.S.A.: 5,517,187; Europe: 0459781; R.S.A.: ZA93/4726
Secure learning patents issued in the U.S.A. and R.S.A. — U.S.A.: 5,686,904; R.S.A.: 95/5429
Ó 1996 Microchip Technology Inc.
DS91002A-page 1
1 page  
TB003
Transmitter Activation
The encoder has an internal power switch which turns
on when any of the button inputs are taken high. When
a button is pressed, the encoder is turned on and the
inputs are sampled after a debounce delay. The
encoder then transmits a code, based on the correct
key, synchronization information, and function codes.
If the time-out option is selection, the encoder will shut-
down after a complete transmission. This mode pre-
vents battery depletion when a push button is
inadvertently activated for an extended period. To acti-
vate the device again, the buttons have to be released
and activated again.
With 28-bit serial number selected:
Hop code
LSB 32 bits
MSB
Serial number
LSB 28 bits MSB
Function
4 bits
Status/CRC
2/3 bits
With 32-bt serial number selected:
Hop code
LSB 32 bits
MSB
Serial number
LSB 32 bits MSB
Status/CRC
2/3 bits
Three data rates are used: 833, 1667, and 3333 bits per second. At the lower transmission rate, a complete transmission
requires approximately 100ms, at the higher rate 50ms, and at the highest rate 25ms. All encoders will transmit the
codes repeatedly while the transmitter is activated.
www.DataSheet4U.com
Ó 1996 Microchip Technology Inc.
DS91002A-page 5
5 Page 
NOTES:
TB003
www.DataSheet4U.com
Ó 1996 Microchip Technology Inc.
DS91002A-page 11
11 Page | ||
| Páginas | Total 12 Páginas | |
| PDF Descargar | [ Datasheet TB003.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| TB003 | An Introduction to KELLOQ Code Hopping | Microchip Technology |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |