파트넘버.co.kr SY10 데이터시트 PDF


SY10 반도체 회로 부품 판매점

SYNCHRONOUS EQUIPMENT STRATUM 3/3E CLOCK UNIT



Raltron Electronics 로고
Raltron Electronics
SY10 데이터시트, 핀배열, 회로
SY10
FEATURES
SYNCHRONOUS EQUIPMENT
STRATUM 3/3E CLOCK UNIT – SY10
Date: August 30, 2002
INTRODUCTION
The SY10 - an accurate time and frequency source
that had been designed as a subsystem level
module. The module is designed to work within ATM,
SONET, SDH, and wireless systems where
synchronization is vital. The SY10 is an excellent
synchronization solution for timing, with jitter and
wander compliance per the specified within ITU-T
Recommendations G.812/G.813 and Bellcore GR-
1244-CORE. The SY10 is an enhanced version of
SY01 and is designed for Stratum 3 and Stratum 3E,
but also holds certain features that can make it
useful for SONET Minimum Clock (SMC) or other
kinds of system clocks.
v A synchronization solution for timing, jitter and wander concerns in a single module.
v Complies with ITU-T Recommendations G.812/813 and Bellcore GR-1244-CORE for Stratum 3 and Stratum
3E applications.
v Supports modes of operation: Locked, Holdover and Free-run.
v Accepts reference inputs from up to six independent sources from 8KHz to 77.76MHz
v Provides up to 3 output from 8KHz to 77.76MHz (Two user select and one fixed at 8KHz)
v Loop filtering utilizing specific software application in the digital signal processor (DSP).
v Continuously monitors and evaluate input reference signals.
v Phase build-out for output clock.
v Creates a history buffer for Holdover mode operation.
v Alarm and status signals and messages.
v Host interface SPI for configuring and remote monitoring.
v Supports Master/Slave configuration of two SY10 with minimum phase error between two clocks.
v Provides “hit-less” switching during switching between the clocks.
v Pin compatible with 18 pins SY01 module.
v Small dimensions of 1.82 x 1.82 x 0.7 inch. (0.60 inch with no mechanical cover)
APPLICATION
The SY10, a Synchronous Equipment Clock (SEC), fulfills clock regeneration function for STRATUM 3 and 3E
equipment for: ATM, SDH, PDH, and SONET networks. It was designed for network system manufacturers such
as: Access Switches, Core Switches, Cross Connects, Digital Multiplexers-Exchangers, and SDH/SONET
equipment. The unit is also suitable for PCS, WLL, and Wireless Base Stations. Wherever a Timing unit with high
performance specifications is required, the SY10 can be embedded within the network system and provide all
necessary frequencies and interfaces.
RALTRON ELECTRONICS CORP. § 10651 N.W.19th St § Florida 33172 § U.S.A.
Tel: 305 593-6033 § Fax: 305-594-3973 § e-mail: [email protected] § Internet: http://www.raltron.com
1


SY10 데이터시트, 핀배열, 회로
SYNCHRONOUS EQUIPMENT
STRATUM 3/3E CLOCK UNIT – SY10
Alarms and Statuses
Ex.Ref.1
Ex.Ref.2
Ex.Ref.3
Ex.Ref.4
Ex.Ref.5
Ex.Ref.6
MUX,
FPD,
Counters
&
Logic
DSP
(RAM,
FLASH)
OCXO
DDS
Output
PLL
Synthesizer
OUT 3
OUT 2
OUT 1
Control Inputs
SPI JTAG
Figure 1. - The functional block diagram of SY10.
DESCRIPTION
The SY10 synchronization module is a Digital PLL (DPLL), which utilizes application specific software in the digital
signal processor (DSP). The DSP is complemented by fast hardware logic (FPGA) where all multiplexers,
counters, dividers, phase detectors, output frequency converters and other control logic circuits are completely
implemented. The functional block diagram with maximum configuration is shown in figure 1. The module has
three phase lock loop – primary PLL, secondary and utility PLL. The primary PLL utilizes a Direct Digital Synthesis
(DDS) technique combined with a high stability OCXO in order to provide an accurate and fast DPLL response and
eliminates the requirement for an OCXO with high pullability. The primary loop is a low bandwidth loop that filters a
major part of the wander and the jitter at the input. The output of the primary PLL is connected to the secondary
PLL synthesizer that is also a DPLL but with a wider loop bandwidth. The secondary PLL loop has also another
input that comes from the SEC IN pin. Depending on the master–slave mode, the secondary loop utilizes either
one of the inputs. The output of secondary PLL is connected to the utility PLL that is an analog phase lock loop.
- The outputs of secondary and utility PLL provide three independent output signals.
- The SPI serial communication interface provides a flow of messages between the module and a host
processor.
- The JTAG interface provides an easy access for future software upgrade re-programming without
removing the module from the system.
The SY10 software provides several features such as:
- switching between the references inputs on the basis of monitoring and estimation of the input signals
and internal state diagram;
- real time calculation of the filtering algorithm for jitter and wander in according to the approved
standards;
- alarm, status and messaging functions using output pins and serial communication port.
For other configurations, please contact Raltron.
ü The module operates in the following three timing modes:
Free-run
In this mode, the unit is unlocked to either of the inputs. The accuracy of the output frequencies in this mode is
±4.6ppm. Free-run mode is typically used when a master clock source is required, not valid history of data for the
Holdover mode, or immediately following system power-up before network synchronization is achieved. In the
Free-run Mode, the SY10 provides timing and synchronization signals that are based on the accuracy of on-board
oscillators only, and are not synchronized to the reference signals.
RALTRON ELECTRONICS CORP. § 10651 N.W.19th St § Florida 33172 § U.S.A.
Tel: 305 593-6033 § Fax: 305-594-3973 § e-mail: [email protected] § Internet: http://www.raltron.com
2




PDF 파일 내의 페이지 : 총 21 페이지

제조업체: Raltron Electronics

( raltron )

SY10 data

데이터시트 다운로드
:

[ SY10.PDF ]

[ SY10 다른 제조사 검색 ]




국내 전력반도체 판매점


상호 : 아이지 인터내셔날

전화번호 : 051-319-2877

[ 홈페이지 ]

IGBT, TR 모듈, SCR, 다이오드모듈, 각종 전력 휴즈

( IYXS, Powerex, Toshiba, Fuji, Bussmann, Eaton )

전력반도체 문의 : 010-3582-2743



일반적인 전자부품 판매점


디바이스마트

IC114

엘레파츠

ICbanQ

Mouser Electronics

DigiKey Electronics

Element14


관련 데이터시트


SY10

SYNCHRONOUS EQUIPMENT STRATUM 3/3E CLOCK UNIT - Raltron Electronics



SY10-100EP451L

3.3V ECL 6-Bit Differential Register - Micrel Semiconductor



SY100

3 Port Solenoid Valve Rubber Seal - SMC



SY100E016

8-BIT SYNCHRONOUS BINARY UP COUNTER - Micrel Semiconductor



SY100E101

QUAD 4-INPUT OR/NOR GATE - Micrel Semiconductor



SY100E104

QUINT 2-INPUT AND/NAND GATE - Micrel Semiconductor



SY100E107

QUINT 2-INPUT XOR/XNOR GATE - Micrel Semiconductor



SY100E111

5V/3.3V 1:9 DIFFERENTIAL CLOCK DRIVER (w/ENABLE) - Micrel Semiconductor



SY100E111A

1:9 DIFFERENTIAL CLOCK DRIVER - Micrel Semiconductor