|
|
Número de pieza | MH101 | |
Descripción | High Dynamic Range MMIC Mixer | |
Fabricantes | ETC | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de MH101 (archivo pdf) en la parte inferior de esta página. Total 3 Páginas | ||
No Preview Available ! MH101
High Dynamic Range MMIC Mixer
The Communications Edge™
Product Information
Product Features
Product Description
Functional Diagram
• +30 dBm Input IP3
The MH101 is a passive GaAs MESFET mixer that
• No External Matching Elements
Required
• RF 1900-2200 MHz
provides high dynamic range performance in a low cost
SOIC-8 package. WJ’s MH101 uses patented tech-
niques to realize greater than +30 dBm Input IP3 at an
LO drive level of +17 dBm.
• LO 1700-2150 MHz
This single monolithic integrated circuit does not
• IF 50-200 MHz
require any external baluns, bias, matching, or decou-
• +17 dBm Drive Level
• Low Cost SOIC-8 Package
• No External Bias Required
pling elements. The on-chip diplexer affords good
matching on the RF and IF ports.
Typical applications include frequency up/down conver-
sion, modulation and demodulation for receivers and
transmitters used in 3G UMTS systems.
4 32 1
5678
Function
RF
LO
IF
Ground
Pin No.
7
2
5
1,3,4,6,8
Specifications
Parameter
Units Minimum Typical Maximum
Condition
Frequency Range:
RF
LO
IF
SSB Conversion Loss
Noise Figure
Input IP3
Input P1dB
Isolation:
L-R
L-I
R-I
Return Loss:
RF Port
LO Port
IF Port
LO Drive Level
MHz
MHz
MHz
1900
1700
50
2200
2150
200
dB 9.0 10.5
dB 9.5
dBm +28
+30
dBm +16
dB 21 28
dB 27 37
dB 12 18
dB 15
dB 12
dB 20
dBm +17
Test conditions unless otherwise noted: RF / IF = 1900 / 50, 1900 / 200, 2200 / 50 and 2200 / 200 MHz with a low-side LO at +17 dBm in a downconverting application at 25°C.
Input IP3 was measured with two tones with an input power of +2 dBm/tone separated by 10 MHz.
Absolute Maximum Ratings1
Parameter
Rating
Operating Case Temperature
Storage Temperature
Maximum Input LO Power2
-40 to +85°C
-65 to +100°C
+21 dBm
1. Operation of this device above any of these parameters may cause permanent damage.
2. Total sum of LO port and RF port power should not to exceed +23 dBm.
Ordering Information
Part No.
MH101
MH101-PCB
Description
High Dynamic Range MMIC Mixer
(Available in tape and reel)
Fully Assembled Application Circuit
Specifications and information are subject to change without notice.
WJ Communications, Inc. • Phone: 1-800-WJ1-4401 • FAX: 408-577-6620 • e-mail: [email protected] • Web site: www.wj.com
February 2004
1 page |
Páginas | Total 3 Páginas | |
PDF Descargar | [ Datasheet MH101.PDF ] |
Número de pieza | Descripción | Fabricantes |
MH101 | High Dynamic Range MMIC Mixer | ETC |
MH101-PCB | High Dynamic Range MMIC Mixer | ETC |
MH102 | High Dynamic Range MMIC Mixer | ETC |
MH103A | High Dynamic Range UMTS-Band MMIC Mixer | ETC |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |