|
|
PDF LA5602 Data sheet ( Hoja de datos )
| Número de pieza | LA5602 | |
| Descripción | Monolithic Linear IC | |
| Fabricantes | Sanyo | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de LA5602 (archivo pdf) en la parte inferior de esta página. Total 5 Páginas | ||
|
No Preview Available !
Ordering number : ENN4281
Monolithic Linear IC
LA5602
Low-Dropout Voltage Regulator with Reset
and On-Off Function
Overview
The LA5602 incorporates both a 5.0V voltage regulator
function and reset generator function into a single-chip
for micro controller power supply application. The
LA5602 supports improvements in efficiency and set
compactness by permitting operation at low input-output
voltage differences.
Functions
• Low dropout regulator with 350mA and 5.0V output
• Power supply reset generator function
• Supports on-off control of 5V using equipped enable
pin (high active)
Features
• Low minimal input-output voltage difference (0.5V
typ.)
• Supports setting of reset output delay time using
external capacitor
• Built-in fold back current limiting circuit and excessive
heat protection circuit
• Reset output using active pull-up for simpler noise
reduction
Package Dimensions
unit : mm
3075-SIP7H
[LA5602]
18.0
3.4
1
1.38 2.54 0.6
7
1.0
3.0
0.6 1.2
SANYO: SIP7H
Any and all SANYO products described or contained herein do not have specifications that can handle
applications that require extremely high levels of reliability, such as life-support systems, aircraft’s
control systems, or other applications whose failure can be reasonably expected to result in serious
physical and/or material damage. Consult with your SANYO representative nearest you before using
any SANYO products described or contained herein in such applications.
SANYO assumes no responsibility for equipment failures that result from using products at values that
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other
parameters) listed in products specifications of any and all SANYO products described or contained
herein.
SANYO Electric Co.,Ltd. Semiconductor Company
TOKYO OFFICE Tokyo Bldg., 1-10, 1 Chome, Ueno, Taito-ku, TOKYO, 110-8534 JAPAN
D2599TH (OT)/10293TS A8-8788, A8-9716 No.4281-1/5
1 page  
LA5602
Specifications of any and all SANYO products described or contained herein stipulate the performance,
characteristics, and functions of the described products in the independent state, and are not guarantees
of the performance, characteristics, and functions of the described products as mounted in the customer’s
products or equipment. To verify symptoms and states that cannot be evaluated in an independent device,
the customer should always evaluate and test devices mounted in the customer’s products or equipment.
SANYO Electric Co., Ltd. strives to supply high-quality high-reliability products. However, any and all
semiconductor products fail with some probability. It is possible that these probabilistic failures could
give rise to accidents or events that could endanger human lives, that could give rise to smoke or fire,
or that could cause damage to other property. When designing equipment, adopt safety measures so
that these kinds of accidents or events cannot occur. Such measures include but are not limited to protective
circuits and error prevention circuits for safe design, redundant design, and structural design.
In the event that any or all SANYO products (including technical data, services) described or contained
herein are controlled under any of applicable local export control laws and regulations, such products must
not be exported without obtaining the export license from the authorities concerned in accordance with the
above law.
No part of this publication may be reproduced or transmitted in any form or by any means, electronic or
mechanical, including photocopying and recording, or any information storage or retrieval system,
or otherwise, without the prior written permission of SANYO Electric Co., Ltd.
Any and all information described or contained herein are subject to change without notice due to
product/technology improvement, etc. When designing equipment, refer to the “Delivery Specification”
for the SANYO product that you intend to use.
Information (including circuit diagrams and circuit parameters) herein is for example only; it is not
guaranteed for volume production. SANYO believes information herein is accurate and reliable, but
no guarantees are made or implied regarding its use or any infringements of intellectual property rights
or other rights of third parties.
This catalog provides information as of December, 1999. Specifications and information herein are
subject to change without notice.
PS No. 4281-5/5
5 Page | ||
| Páginas | Total 5 Páginas | |
| PDF Descargar | [ Datasheet LA5602.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| LA5601 | Monolithic Linear IC | Sanyo |
| LA5602 | Monolithic Linear IC | Sanyo |
| LA5603 | Monolithic Linear IC | Sanyo |
| LA5603 | Monolithic Linear IC | Sanyo |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |