N34C04 반도체 회로 부품 판매점
4-Kb Serial SPD EEPROM
|
|
 ON Semiconductor |
N34C04
4-Kb Serial SPD EEPROM
for DDR4 DIMM
Description
The N34C04 is a 4−Kb serial EEPROM, which implements the
JEDEC JC42.4 (EE1004−v) Serial Presence Detect (SPD)
specification for DDR4 DIMMs and supports the Standard (100 kHz),
Fast (400 kHz) and Fast Plus (1 MHz) I2C protocols.
One of the two available 2−Kb EEPROM banks (referred to as SPD
pages in the EE1004−v specification) is activated for access at
power−up. After power−up, banks can be switched via software
command. Each of the four 1−Kb EEPROM blocks can be Write
Protected by software command.
Features
• JEDEC JC42.4 (EE1004−v) Serial Presence Detect (SPD) Compliant
• Temperature Range: −40°C to +125°C
• Supply Range: 1.7 V − 3.6 V
• I2C / SMBus Interface
• Schmitt Triggers and Noise Suppression Filters on SCL and SDA
Inputs
• 16−Byte Page Write Buffer
• Hardware Write Protection for Entire Memory
• Low Power CMOS Technology
• 2 x 3 x 0.5 mm UDFN Package
• These Devices are Pb−Free and are RoHS Compliant
VCC
SCL
A2, A1, A0
WP
N34C04
SDA
VSS
Figure 1. Functional Symbol
www.onsemi.com
1
UDFN8
MU3 SUFFIX
CASE 517AZ
PIN CONFIGURATION
A0 1
A1
(Top View)
A2
VSS
VCC
WP
SCL
SDA
UDFN (HU4)
For the location of Pin 1, please consult the
corresponding package drawing.
MARKING DIAGRAM
D2U
AZZ
YM
G
UDFN8
D2U
A
ZZ
Y
M
G
= Specific Device Code
= Assembly Location Code
= Assembly Lot Number (Last Two Digits)
= Production Year (Last Digit)
= Production Month (1 − 9, O, N, D)
= Pb−Free Package
PIN FUNCTIONS
Pin Name
Function
A0, A1, A2
SDA
SCL
WP
Device Address Input
Serial Data Input/Output
Serial Clock Input
Write Protect Input
VCC
VSS
DAP
Power Supply
Ground
Backside Exposed DAP at VSS
ORDERING INFORMATION
See detailed ordering and shipping information in the package
dimensions section on page 11 of this data sheet.
© Semiconductor Components Industries, LLC, 2016
November, 2016 − Rev. 0
1
Publication Order Number:
N34C04/D
N34C04
Table 1. ABSOLUTE MAXIMUM RATINGS
Parameter
Rating
Units
Operating Temperature
−45 to +130
°C
Storage Temperature
−65 to +150
°C
Voltage on any pin (except A0) with respect to Ground (Note 1)
−0.5 to +6.5
V
Voltage on pin A0 with respect to Ground
−0.5 to +10.5
V
Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality
should not be assumed, damage may occur and reliability may be affected.
1. The DC input voltage on any pin should not be lower than −0.5 V or higher than VCC + 0.5 V. The A0 pin can be raised to a HV level for SWP
command execution. SCL and SDA inputs can be raised to the maximum limit, irrespective of VCC.
Table 2. RELIABILITY CHARACTERISTICS
Symbol
Parameter
NEND (Note 2)
Endurance
TDR Data Retention
2. Page Mode, VCC = 2.5 V, 25°C
Min
1,000,000
100
Units
Write Cycles
Years
Table 3. THERMAL CHARACTERISTICS (Note 3)
Parameter
Test Conditions/Comments
Max Unit
Thermal Resistance qJA
Junction−to−Ambient (Still Air)
92 °C/W
3. Power Dissipation is defined as PJ = (TJ − TA)/qJA, where TJ is the junction temperature and TA is the ambient temperature. The thermal
resistance value refers to the case of a package being used on a standard 2−layer PCB.
Table 4. D.C. OPERATING CHARACTERISTICS (Vcc = 1.7 V to 3.6 V, TA = −40°C to +125°C, unless otherwise specified)
Symbol
Parameter
Test Conditions
Min Max Units
ICCR
ICCW
ISB
Read Current
Write Current
Standby Current
Read, fSCL = 400 kHz or 1 MHz
Write, during tWR (Note 4)
All I/O Pins at
GND or Vcc
Vcc < 2.2 V
Vcc ≥ 2.2 V
1 mA
1 mA
1 mA
2
IL I/O Pin Leakage
Pin at GND or VCC
2 mA
VIL Input Low Voltage
−0.5 0.3*Vcc
V
VIH Input High Voltage
0.7*Vcc VCC + 0.5
V
VOL1
Output Low Voltage
VCC ≥ 2.2 V, IOL = 20 mA
0.4 V
VOL2
Output Low Voltage
VCC < 2.2 V, IOL = 6.0 mA
0.2 V
VPOR+
Power On Reset Threshold
(Note 4)
1.3 V
VPOR−
Power Off Reset Threshold
(Note 4)
0.8 V
4. Tested initially and after a design or process change that affects this parameter
Product parametric performance is indicated in the Electrical Characteristics for the listed test conditions, unless otherwise noted. Product
performance may not be indicated by the Electrical Characteristics if operated under different conditions.
www.onsemi.com
2
|
PDF 파일 내의 페이지 : 총 11 페이지
제조업체: ON Semiconductor
( onsemi )
N34C04 data
데이터시트 다운로드 :
[ N34C04.PDF ]
[ N34C04 다른 제조사 검색 ]
국내 전력반도체 판매점
상호 : 아이지 인터내셔날
전화번호 : 051-319-2877
[ 홈페이지 ]
IGBT, TR 모듈, SCR, 다이오드모듈, 각종 전력 휴즈
( IYXS, Powerex, Toshiba, Fuji, Bussmann, Eaton )
전력반도체 문의 : 010-3582-2743
